Improve the Effective Sterilization Environment by Autoclaves

Heat is the most common among the physical agents used for the decontamination of pathogens. “Dry” heat, which is totally non-corrosive, is used to process many items of laboratory ware which can withstand temperatures of 160 °C or higher for 2–4 h. Burning or incineration is also a form of dry heat. “Moist” heat is most effective when used in the form of autoclaving. Sterilized items must be handled and stored such that they remain uncontaminated until used.The following describes the autoclave.

Saturated steam under pressure (autoclaving) is the most effective and reliable means of sterilizing laboratory materials. For most purposes, the following cycles will ensure sterilization of correctly loaded autoclaves:

1.3 min holding time at 134 °C

2. 10 min holding time at 126 °C

3. 15 min holding time at 121 °C

4. 25 min holding time at 115 °C

AUTOCLAVE

灭菌器

Loading autoclaves

Materials should be loosely packed in the chamber for easy steam penetration and air removal. Bags should allow the steam to reach their contents.

Precautions in the use of autoclaves

The following rules can minimize the hazards inherent in operating pressurized vessels.

  1. Responsibility for operation and routine care should be assigned to trained individuals.
  2. A preventive maintenance programme should include regular inspection of the chamber, door seals and all gauges and controls by qualified personnel.
  3. The steam should be saturated and free from chemicals (e.g. corrosion inhibitors) that could contaminate the items being sterilized.
  4. All materials to be autoclaved should be in containers that allow ready removal of air and permit good heat penetration; the chamber should be loosely packed so that steam will reach the load evenly.
  5. For autoclaves without an interlocking safety device that prevents the door being opened when the chamber is pressurized, the main steam valve should be closed and the temperature allowed to fall below 80 °C before the door is opened.
  6. Slow exhaust settings should be used when autoclaving liquids, as they may boil over when removed due to superheating.
  7. Operators should wear suitable gloves and visors for protection when opening the autoclave, even when the temperature has fallen below 80 °C.
  8. In any routine monitoring of autoclave performance, biological indicators or thermocouples should be placed at the centre of each load. Regular monitoring with thermocouples and recording devices in a “worst case” load is highly desirable to determine proper operating cycles.
  9. The drain screen filter of the chamber (if available) should be removed and cleaned daily.
  10. Care should be taken to ensure that the relief valves of pressure cooker autoclaves do not become blocked by paper, etc. in the load.

  • Previous:
  • Next:

  • Post time: Feb-17-2022